Play the whole four-piece section or divide into classic subsections, playing only two trumpets, or just sax and trombone, for example.Īs well as sampling a wide range of articulations,Į-instruments sampled all possible note transitions from all four instruments. These come to play in Legato mode – play melodies and SESSION HORNS automatically handles the note transitions, smoothing the melodies you play and adding a new depth of expression and authenticity. SESSION HORNS is the express route to authentic horns for producers of any ability. The unique Smart Voice Split automatically allocates each note of a chord to the corresponding brass instrument, just as an arranger would. Press two keys, and the instruments split into lower and higher ranges – trumpets at the top and sax and trombone at the bottom. Play three keys, and the trombone is automatically mapped to the lowest note. It seems that I somehow need to have Kontakt create separate outputs for one instance of the plugin and I'm not sure how to do that or even if I'm going about this the correct way.Add a fourth note below, and the trombone takes up the new bass note, while the higher pitches are allocated to the rest of the ensemble. st.1 and which was the main output of the kontakt plugin. 1 which was already there by default and that st. I believe this is because I set the trumpet to st. But the sax and two trombones are nowhere to be found in channels 2-4. The only channel that works is Channel 1 and it successfully picks up the Trumpet only. I made 4 Midi Out plugins and set the Channels for each one of them 1-4. They are definitely separated correctly here and each output is playing a different instrument.Īfter this, I went back into FL Studio and clicked on the Kontact plugin and then clicked the gear icon and set the input port to 0. I routed the output of each instrument to the 4 different 'st.' outputs. I then clicked the wrench at the top left, right next to where it says' Session Horns Pro - Performance' and chose 'Instrument Buses'. st.1 and which is the Output of the Session Horns plugin inside Kontakt. aux 3-8 (two per channel for st.2-4) except for st. 'st.' output and set the 'physical out' for each channel to kt. I added 3 more outputs for a total of 4, st.

So there are 4 horns within 1 instance of Session Horns. How do I send them individually to the mixer in FL Studio? I have 4 Horns in NI Kontakt Session Horns Pro.

Kontakt session horns pro